Filter
Top Products
54 En
DAB (Digital Audio Broadcasting)
3 Press ENTER to confirm your selection.
The unit begins scanning the selected band(s) for
DAB ensembles.
• During the scan, “Scanning” appears in the front
panel display.
• When the scan has been completed, “FINISH”
appears in the front panel display, followed by the
number of a receivable DAB service.
“FINISH [###]” is displayed for three seconds.
Scanning xx%
FINISH [015]
(Example: if 15 services were found.)
After three seconds, this unit returns to the DAB
tuning mode automatically.
If the INIT SCAN operation was not successful, “Not
Available” appears in the front panel display.
FINISH [000]
Not Available
y
See the DAB section in “Troubleshooting” for further
details or proper remedies (see page 116).
If there are no preset DAB services, “Initiate Scan” or
“Not Available” appears in the front panel display.In this
time, press / to start INIT SCAN automatically.
TUNE AID displays the strength of the DAB signal being
received by this unit in the front panel display. Use TUNE
AID to adjust the positioning of the indoor DAB antenna
and this unit and discover which setup has the best
reception state. It is recommended that you use TUNE
AID when setting up this unit in order to maximize DAB
reception ability.
1 Access DAB MENU by following steps 1
through 4 as described in “Accessing DAB
MENU” on page 53.
“INIT SCAN” appears in the front panel display.
2 Press once.
“TUNE AID” appears in the front panel display.
3 Press ENTER.
The signal strength level of the selected channel
appears in the front panel display. The signal strength
ranges from 00 (none) to 100 (best).
4 Press / to switch to another channel
label.
The signal strength level of the new channel appears in
the front panel display. For a list of DAB frequencies,
see “DAB frequency table” on page 119.
5 Press ENTER to exit from TUNE AID.
The unit returns to the TUNE AID menu display.
ENTER
BBC Radio 4
TUNE AID
INIT SCAN
TUNE AID
ENTER
11B / LEVEL: 80
ENTER
11C / LEVEL: 40
ENTER
TUNE AID
ENTER