Filter
Top Products
93 En
MANUAL SETUP
ADVANCED
OPERATION
English
■ OSD SET (OSD settings)
Use to adjust the display position and to set the display
time of the OSD.
OSD SHIFT (OSD shift)
Use to adjust the vertical position of the OSD. Adjust
toward the – (minus) direction to raise the position of the
OSD, and adjust toward the + (plus) direction to lower it.
Choices: –5 to +5
Initial setting: 0
OSD DISPLAY TIME (OSD display time)
Use to set the interval for which the OSD screen is
displayed after an operation.
Choices: ON, 10s, 30s
• Select ON to show the OSD screen constantly.
• Select 10s to turn off the OSD screen 10 seconds after
an operation.
• Select 30s to turn off the OSD screen 30 seconds after
an operation.
y
The OSD display time setting is available for your iPod (see
page 58).
■ UNIT SET (Unit settings)
Use this to change the display unit of measurement.
Choices: METERS, FEET
• Select METERS to enter distances in meters.
• Select FEET to enter distances in feet.
If you change this setting, the adjusted sound beam settings may
change.
Note
OSD SHIFT;;;;;;;;;;0
OSD DISPLAY TIME;;;ON
[ ]/[ ]:Up/Down [ ]/[ ]:Sel
[ENTER]:Return
B)OSD SET
p
p
.
p
p
METERS FEET
[ ]/[ ]:Select
[ENTER]:Return
p
p
C)UNIT SET
p