Filter
Top Products
Ribbon Loading Instructions
NOTES:
Zebra recommends the use of ribbon that is wider than the media. The
smooth backing of the ribbon protects the printhead from wear and
premature failure due to excessive abrasion. (For the direct thermal
print method, ribbon is not used and should not be loaded in the
printer.)
Zebra recommends the use of ribbon that is outside wound (the ink side
is on the outside of the roll).
To load ribbon, see Figure 12 and follow the procedure below.
1. Adjust the ribbon supply spindle position for normal or low tension.
2. Align the blades (b) on the two sections of the spindle as shown in
Figure 11. (You do not need to do this if your ribbon width is 2.4"
[60 mm] or less.)
3. Place the ribbon roll on the ribbon supply spindle (a). Make sure the roll
is pushed in to the stop at the end of the spindle.
4. Open the printhead by moving the head open lever (b) counterclockwise
to the open position.
5. Thread the ribbon as shown. Wind the ribbon onto the ribbon takeup
spindle (c) for several turns in a clockwise direction until wrinkles and
creases disappear.
6. Close the printhead by moving the lever clockwise to the closed posi-
tion.
S400 & S600 User’s Guide 13
21