Filter
Top Products
38
Appendix A
Zebra
Xilll
Series SL5000r/T5000r with ZGL Emulation
Print Width - Width of image to be printed in
Inches, MM or Dots.
Printer width dependent.
QUICK SETUP Menu,
Label Width - Width of image to be printed in Inches or
MM.
Printer width dependent.
Label Length - Printable length of label in
Inches or MM.
QUICK SETUP Menu,
Label Length - Printable length of label in Inches or MM.
Maximum Length - Used to assist in media
calibration only.
CALIBRATE CTRL Menu,
Use Label Length – (Enable*) Uses Label Length value
in QUICK SETUP menu to assist in Auto Calibrate
procedure.
Parallel Comm. -
Parallel*
Twinax/Coax (option)
PARALLEL PORT Menu,
Port Type - IEEE 1284*, Disable or Centronics. NOTE:
Use C/T PORT Menu if Coax/Twinax option installed.
Serial Comm. -
RS232*, RS422/485 or RS485 multidrop.
SERIAL PORT Menu,
Port Type -
RS232*, RS422 or Disable.
Baud - (110 - 57600) 9600* Baud Rate - (600 - 115200) 9600*
Data Bits - 7-bits* or 8-bits Word Length 7 or 8*
Parity - (Even*, Odd or None) Parity - (Even, Odd or None*)
Stop Bits - 1 stop bit* or 2 stop bits Stop Bits - 1* or 2
Host Handshake -
XON/XOFF*, DTR/DSR
Protocol - None*, Zebra or ACK/NAK
Data Protocol -
XON/XOFF*, ETX/ACK, ACK/NAK, Series 1 Char, Series
2 Char or DTR
Network ID (000* - 999) used for RS-422/
RS-485 Network only.
N/A
Communications -
Normal Mode* - Prints label image.
Diagnostics - All data sent from host printed
in ASCII hex chars.
NOTE: Ptr Defaults to Normal Mode Comm. Hex Dump
(same as Zebra Diagnostic Mode) can be Enabled in
DIAGNOSTIC Menu.
Control Prefix - (00 – FF) Hex 7E* PPI/ZGL SETUP Menu,
Command Prefix - (1-255) 126*.
= Hex 7E*
Format Prefix - (00-FF) Hex 5E* Label Prefix - (1 to 255) 94*. = Hex 5E*
Delimiter Char. - (00-FF) Hex 2C* Delimiter - (1 to 255) 44*. = Hex 2C*
ZPL Mode - ZPLII*, ZPL ZPL Compatibility - ZPL-II*, ZPL-1
Table 2: ZGL Menu (continued)