Filter
Top Products
40
Appendix A
Zebra
Xilll
Series SL5000r/T5000r with ZGL Emulation
Head Resistor - Must be updated when
printhead changed.
NOTE: Head Resistance detected & updated
automatically by SW.
Verifier Port - How printer reacts to Optional
On-Line Verifier.
Off* - Verifier port is off.
1 VER-RPRINT - Label reprinted if error
detected.
2 VER-THRUPUT - Allows greatest
throughput but may not indicate verification
error immediately.
Off - Default if no validator installed.
VALIDATOR Menu (Opt),
Validator Funct. - Enable*, Disable. Automatically
Enabled when opt installed. Disable = Validator turned off.
Validator Action -
Retry Form* - Label reprinted if error detected.
Applicator Port N/A
Web S. - Auto set during calibrate. Automatically set during Auto Calibrate.
Media S. Auto set during calibrate. Automatically set during Auto Calibrate.
Ribbon S. - Auto set during calibrate. Automatically set after power up, while printing and when
printhead is opened then closed.
Mark S. - Auto set during calibrate. Automatically set during Auto Calibrate.
Mark Med S. - Auto set during calibrate. Automatically set during Auto Calibrate.
Media LED - Automatically set during
calibrate.
Automatically set during Auto Calibrate.
Ribbon LED - Automatically set during
calibrate.
Automatically set during Auto Calibrate.
Mark LED - Automatically set during
calibrate.
Automatically set during Auto Calibrate
LCD Adjust- Adj. display brightness. N/A
Resolution - Full*, Half. PPI/ZGL SETUP Menu,
Resolution Mode - Full*, Half
Firmware - Firmware version & part number
printed.
DIAGNOSTIC Menu,
Software Build & Config printout
Language - Sets the display language.
English*, Spanish, French, German, Italian,
Norwegian, Portuguese, Swedish, Danish,
Spanish2, Dutch, Finnish, Custom.
PRINTER CONTROL Menu, Display Language -
English*, Spanish, French, German, Italian, Portuguese.
Table 2: ZGL Menu (continued)