ZyXEL Communications 2602RL-D3A Modem User Manual


 
Prestige 2602RL-D3A Support Notes
All contents copyright (c) 2007 ZyXEL Communications Corporation.
22
Overload mapping. Select Full Feature when you
require other mapping types. It is a convenient,
pre-configured, read only, Many-to-One mapping set,
sufficient for most purposes and helpful to people
already familiar with SUA in previous ZyNOS
versions. Note that there is also a Server type whose
IGA is 0.0.0.0 in this set.
Table: Applying NAT in Menu 4 and Menu 11.3
2. Configuring NAT
To configure NAT, enter 15 from the Main Menu to bring up the following screen.
Menu 15 - NAT Setup
1. Address Mapping Sets
2. NAT Server Sets
3. Address Mapping Sets and NAT Server Sets
Use the Address Mapping Sets menus and submenus to create the mapping table used to assign global addresses
to LAN clients. Each remote node must specify which NAT Address Mapping Set to use. The P2602RL has 8
remote nodes and so allows you to configure 8 NAT Address Mapping Set. You can see nine NAT Address
Mapping sets in Menu 15.1. You can only configure from Set 1 to Set 8. Set 255 is used for SUA. When you
select Full Feature in menu 4 or 11.3. When you select SUA Only, the SMT will use Set 15.2.
The NAT Server Set is a list of LAN side servers mapped to external ports. To use this set (one set for the
Prestige), a server rule must be set up inside the NAT Address Mapping set. Please see NAT Server Sets for
further information on these menus.
Enter 1 to bring up Menu 15.1-Address Mapping Sets