Filter
Top Products
Chapter 25 Access Control
GS-3012/GS-3012F User’s Guide
179
Click Access Control from the navigation panel and then click Logins from this screen.
Figure 97 Access Control: Logins
The following table describes the labels in this screen.
Table 66 Access Control: Logins
LABEL DESCRIPTION
Administrator
This is the default administrator account with the “admin” user name. You cannot change the default
administrator user name. Only the administrator has read/write access.
Old Password Type the existing system password ("1234" is the default password when
shipped).
New Password Enter your new system password.
Retype to confirm Retype your new system password for confirmation
Edit Logins
You may configure passwords for up to four users. These users have read-only access. You can give
users higher privileges via the CLI. For more information on assigning privileges see Chapter 32 on
page 207.
User Name Set a user name (up to 32 ASCII characters long).
Password Enter your new system password for the user name above.
Retype to confirm Retype your new system password for confirmation
Apply Click Apply to save your changes to the switch’s run-time memory. The switch
loses these changes if it is turned off or loses power, so use the Save link on the
top navigation panel to save your changes to the non-volatile memory when you
are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.