Flipper Assembly
1 Remove all paper bins and the blind cover (see Figure 6-86).
2 Remove the Left and Right Covers (see Figure 6-65).
3 Remove the Delivery Head Position Motor (see Figure 6-82).
4 Remove the Jam Access Door (see Figures 6-74 through 6-76).
5 Remove the (2) inside screws closest to the front of the unit, CH112
(Figure 6-70, callout 2).
6 Unplug the ground wire from the Flipper Roller Motor (Figure 6-71,
callout 3).
7 Tilt the right end of the assembly a few inches out of the frame, unplug the
cable (see Figure 6-69), and rotate the assembly free while feeding the
motor cable out through the access opening on the left side.
To Reinstall:
Caution
Do not over tighten the screws (Figure 6-70, callout 2), when replacing the
Flipper Assembly. The nuts in the Flipper Assembly will rotate in their
retaining slots.
Multi-Bin Mailbox/Mailbox with Stapler, Flipper Assembly Connector
Figure 6-69
6
Removal and
Replacement
Removal and Replacement 6-83
