A SERVICE OF

logo

Configuring Apple EtherTalk Phase Parameter
To configure EtherTalk parameters:
1 If you do not want to configure the phase parameter, Press [On Line].
2 Press [Item]. CFG ETALK=NO * appears.
3 Press [+]. CFG ETALK=YES appears.
4 Press [Select]. CFG ETALK=YES * appears.
5 Press [Item]. Phase=2 * appears.
6 Press [+] to change the phase parameter. Phase=1 appears.
7 Press [Select] to save the new value. Phase=1 * appears.
8 Press [On Line]. You may want to configure the AppleTalk name and assign
a preferred EtherTalk Zone.
9 After completing this guide refer to the HP JetDirect Interface
Configuration Guide for further configuration instructions on using the HP
LaserJet Utility.
B
I/O Information
I/O Information B-9