Restoring Factory Defaults
Caution
If possible, print a PCL Configuration Page prior to performing a Cold
Reset. This will document current settings for later reference.
Performing a Cold Reset resets the JetDirect configuration. To avoid
making changes to your configuration, remove the JetDirect card before
performing a cold reset
1 Press and hold [On Line] while powering the printer ON.
2 Hold down [On Line] until RESTORING FACTORY SETTINGS message appears.
This message is followed by the power-on INTERNAL TEST message. The
printer then re-displays RESTORING FACTORY SETTINGS until the power-on
initialization is completed. The factory defaults are listed in Table 3-3.
Setting the Display Language
1 Press and hold [Select] while powering ON. Hold [Select] until CONFIG
LANGUAGE appears.
2 Release [Select]. INTERNAL TEST appears briefly. Wait for LANGUAGE=ENGLISH
to appear.
3 Press [+] repeatedly until the desired language appears.
4 Press ]Select] to save your choice. An asterisk (*) will appear beside your
language selection.
3-6 Operating Overview
