A SERVICE OF

logo

Accessing the command line interface 14
Pin Name Signal direction Description
4
DTR -->> Data terminal ready
5
GND
System ground
6
DSR <<-- Data set ready
7
RTS -->> Request to send
8
CTS <<-- Clear to send
9
RI <<-- Ring indicator
2. Use any standard communication software to launch a terminal emulation session with the following
parameters:
Parameter Value
Transmission rate
9600 bps
Data bits
8
Parity
None
Stop bits
1
Protocol
None
3. When prompted, enter a valid user name, and then press Enter.
4. Enter a valid password, and press Enter. The CLI command prompt appears.
5. Enter commands for the Onboard Administrator.
6. To terminate the terminal session, enter Exit at the prompt.