Displaying Information About the Access Server
17-20 Managing the Access Server
Load Address Ethernet address of the node or the gateway from
which the access server was last loaded. Some
access servers display all zeroes if a downline load
occurs using BOOTP and TFTP.
Dump Address Ethernet address of the node or gateway that
received the last up-line dump. Some access servers
display all zeroes if a dump is to an Internet host.
Console User Address of the node at which the Remote Console
Facility (RCF) is being used to access the access
server. The access server indicates “none available”
if the RCF is not in use.
Boot Protocol This is the protocol used to downline load the
software.
Selftest Status Shows internal information if the result of self-test
at the most recent access server initialization is other
than:
Normal: Server: 00-00-00 Service: 00000 Port:
0000000000000000
If a nonfatal error occurs during self-test, the access
server displays information about the error. The
following describes the information that appears in
the display: Selftest Status: 00-00-00: The leftmost
two numbers are always 00. The third number is a
hexadecimal representation of a bit map in which a
bit set indicates status as follows:
Bit
1
2
4
8
20
40
80
Field Description
