41
.
Initial setup
This chapter includes the following topics:
Topic
“Before you begin” (page 41)
“About the IP addresses” (page 42)
“Initial setup” (page 43)
“Setting up a single Nortel SNAS device or the first in a cluster” (page 43)
“Adding a Nortel SNAS device to a cluster” (page 50)
“Next steps” (page 54)
“Applying and saving the configuration” (page 55)
Before you begin
Before you can set up the Nortel SNAS, you must complete the following
tasks:
Step Action
1 Plan the network. For more information, see Nortel Secure
Network Access Solution Guide, (NN47230-200).
In order to configure the Nortel SNAS, you require the following
information:
• IP addresses
— Nortel SNAS Management IP address (MIP), portal Virtual
IP address (pVIP), Real IP address (RIP)
— default gateway
— DNS server
— NTP server (if applicable)
— external authentication servers (if applicable)
Nortel Secure Network Access Switch
Using the Command Line Interface
NN47230-100 03.01 Standard
28 July 2008
Copyright © 2007, 2008 Nortel Networks
.
