Programming Codes iTherm
®
280 Programmer’s Guide
Page 114 Rev C 28-07764
Receipt or
Inserted Form
B > > > > >
A > > > > >
D > > > > >
C > > > > >
Initial entry
location
Figure 10 Page Mode Entry Orientations
The [ESC] u command wet the maximum page dimensions. Note that these dimensions
are always based on 0 degree rotation.
Enter text and/or graphics as required.
Auto-cutter and page mode
You may embed an auto-cutter command with in a page definition. The auto-cut
command may be placed anywhere in the page definition, however, it will be processed
after the page is printed. To prevent the cut from occurring in the page, it will be
preceded with a feed that will place the end of the page about 0.125 inches above the
auto-cut position.
Mechanism commands in page mode
In general, mechanism commands received during page mode will be processed if the
result will not affect the printed result.
Stopping page mode definition
The following operations will stop a page mode definition:
1) [ESC]@ Printer initialize command.
2) Real time reset request [ENQ]<10>
3) Turning the printer off.
Printing the page
The [FF] command starts the printing process.
Printing starts at the current paper position. The complete page definition is printed
excluding any blank information at the bottom of the page.
If the [FF] command is used to print the page, the memory used to store the page image
is not maintained and is released to be used by other functions.
Function Select page mode
