Specifications and Requirements iTherm
®
280 Programmer’s Guide
Page 22 Rev C 28-07764
• CPI selections from 8 to 30 CPI
1
• Paper Out sensor
• Multiple printer emulations: Ithaca PcOS and Epson Extended,
• Maximum 8K buffer (adjustable)
• 2 Megabytes Flash Memory
• 2 Megabytes RAM
• APA and Epson graphics
• Bar Codes: Code 39, Code 93, Code 128, Interleaved 2 of 5, UPC-A, UPC-
E, EAN-8, EAN-13, EAN-14, PDF417 stacked symbology and Codabar
• WGL4.0 Character set.
• Metal receipt tear off
• 8 dots/mm. thermal print head resolution
• ON/OFF button located on front of printer
• Cable routing strain relief
• Power/Error/Paper LEDs
• Paper feed button
• Cover open button
• Settable cash drawer configurations (Ithaca, Epson, or Star)
• Spill proof design- vertical main PCB mounting
• 58 mm. or 80 mm. paper width – factory-settable
• 4.0 inch (101 mm.) Paper roll diameter
• Portrait/landscape printing under Windows
• Page mode printing
• Cover Open sensor
• Electronic journal capability
• Internal counters for hours on, cuts, print lines and errors
• 100 km print head life
• 60 million print line printer MCBF (excluding knife)
• Strong break-away paper cover
• 1,000,000 cuts cutter life (partial cut)
• Buzzer
• 2 color printing (4 inches per second print speed)
1
Character spacing is adjustable from 1 to 30 CPI. Typical values will be between 8 and 20 CPI
depending on the font selected. Values of 13.3, 14.86, or 17.3 are typical for each resident font.
2
CPI’s greater than 16 will not be supported in NLQ fonts
