A SERVICE OF

logo

2–2
SCANTEAM 3700 Wedge Technical Manual
2.2 Connecting to a PC
Install the 3700 Wedge by following the steps shown below:
Disconnect power to the terminal/computer by turning the host system
OFF.
Connect the interface cable to the 3700 Wedge and to the
terminal/computer and to the keyboard.
(Cable, Keyboard, and Terminal will vary.)
Disconnect
Once the 3700 Wedge has been fully connected, restore power to the
terminal/computer by turning the host system power ON.
Scan Terminal Interface Bar Code
You must program the3700 Wedge to work withyour terminal or computer
by scanning the appropriate programming bar code(s).
For further installation and mounting information, see Chapter 10.