4–7SCANTEAM 3700 Wedge Technical Manual
Output Delays
This programming selection provides control of the Output Delays, which are
time delays between data output by the 3700 Wedge to the host terminal.
(Specific output delays are described below.) The actual delay is 5 milliseconds
multiplied by the programmed value (00 - 99). Default = 00.
Note: To select digits 0 through 9, use the Programming Chart found on the
inside of theback cover of thismenu. Scanthe programmingselection bar code
first, and then scan the bar code(s) representing the digits you wish to set.
Example:
H You need a 45 millisecond delay. Scan the Intercharacter Delay bar
code. Then scan 0" and 9" on the Programming Chart (09 x 5ms =
45 ms). Two digits are always required for a delay setting.
Intercharacter Delay is the time delay between data characters output by the
3700 Wedge to the host terminal.
Interfunction Delay is the time delay between function (key) codes output by
the 3700 Wedge to the host terminal.
Intermessage Delay is the time delay between data messages or records
output by the 3700 Wedge to the host terminal.
Interfunction Delay (x5mS) ]
Intermessage Delay (x5mS) ]
] A twoĆdigit number is required after scanning this programming bar code.
Please scan your selection on the Programming Chart (inside back cover).
Intercharacter Delay (x5mS) ]
