11–2
SCANTEAM 3700 Wedge Technical Manual
Does the 3700 Wedge read your bar code incorrectly?
If the 3700 Wedge reads a bar code (one beep for a good read), but the
bar code is not displayed correctly on the host screen:
➊ The 3700 Wedge may not be programmed for the appropriate
terminal interface.
Example: You scan 12345" and the host displays @es%."
Reprogram the3700 Wedge withthe correct or Terminal Selection bar
code (see Section 2, Quick Start Menu).
➋ The 3700 Wedge may not be programmed to output your bar code
properly.
Example: You scan 12345" and the host displays A12345B."
Reprogram the 3700 Wedge with the proper Symbology selections
(see Section 5, Symbology Menu).
The 3700 Wedge won’t read your bar code at all?
If the 3700 Wedge will not read your bar code:
➊ Try scanning the Sample Bar Codes (found at the end of the Default
Charts section.
If the 3700 Wedge reads
the Sample Bar Codes, check that your bar
code is readable. (See Is the 3700 Wedge having trouble reading
your bar codes" on the previous page.)
If the 3700 Wedge does not read
the Sample Bar Codes either,
continue to #2, below...
➋ If the 3700 Wedge won't read the Sample Bar Codes either:
Verify that the bar code symbologies are enabled. (See Sections 5,
Symbology Menu.)
Verify that your bar code symbology is enabled. (See Sections 5,
Symbology Menu.)
Scan the Default All... " bar code on each symbology menu page in
Section 5 to enable most symbologies. (MSI and Plessey will have to
be enabled individually, as they are defaulted Off.)
