3Com 3C16020 Power Supply User Manual


 
E
L
E
C
T
R
O
-M
A
G
N
E
T
I
C
C
O
M
P
A
T
A
B
I
L
I
T
Y
S
T
A
T
E
M
E
N
T
S
Federal Communications Commission Radio and Television
Interference Statement for Class B Devices
This equipment has been tested and found to comply with the limits for Class B
digital devices, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one of the following measures.
User Instructions:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Ensure that card mounting screws, connector attachment screws and all ground
wires are secured and tight.
Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment. This product
was FCC certified under test conditions that included the use of shielded I/O cable
and connectors between system components. To be in compliance with FCC
regulations, the user must use shielded cables and connectors and install them
properly.
CSA STATEMENT
This Class B digital apparatus meets all requirements of the Canadian
Interference-Causing Equipment Regulations.
Cet appareil numérique de la classe B respecte toutes les exigences du Règlement
sur le matériel brouilleur du Canada.