Filter
Top Products
Software Upgrade 85
■ Loading using TFTP and through Ethernet port
■ Loading using FTP and through Ethernet port
2 Local or remote loading through CLI:
■ Loading using FTP
■ Loading using TFTP
Local Loading through
Boot Menu
Boot menu
After powering on the Switch, run Boot ROM program first and the terminal will
display the following information:
ZBB_TEST
Starting...
*************************************************
* *
* 3Com Switch 8800 Family Bootrom, Version 109
*
* *
*************************************************
Copyright(C) 2001-2005 by 3Com CORPORATION
Creation date: Dec 9 2003, 16:19:42
CPU type : MPC755
CPU L2 Cache : 1024KB
CPU Clock Speed : 400MHz
BUS Clock Speed : 100MHz
Memory Size : 512MB
Flash file system init....done
Board type: Switch 8800 Family 3C17539
Board self testing...........................
The board is steady
SlotNo of this board is 6
The MCX is exist
BootRom main system CRC check is OK
82559 register testing is OK
EPLD1 testing is OK
EPLD2 testing is OK
16c2552 register testing is OK
Please check LEDs......................LED testing finished
The switch Mac address is 00e0.fc00.1111
Press Ctrl+B to enter Boot Menu... 5
Password :
Press <Ctrl+B> as prompted and the system will display:
Password :
n
To enter the Boot menu, you must press <Ctrl+B> within five seconds after the
appearance of the prompt “Press Ctrl-B to enter Boot menu...”. Otherwise, the
program decompression process will begin. To access the Boot menu after the
Switch enters the program decompression process, you need to restart the Switch.
Enter the correct Boot ROM password (no password has been set for the switch by
default), and the system will access the Boot menu: