Filter
Top Products
Specifications A - 9
Using the RMON MultiProbe Module SLIP Address
To communicate with the RMON MultiProbe Module, the client software
must use the RMON MultiProbe Module local SLIP address as the module
destination IP address. For information on configuring a
SLIP route to a
device, refer to the workstation UNIX® manual.
Over a SLIP connection, the RMON MultiProbe Module supports the
following configuration:
❑ Various baud rates (refer to the Serial Configuration menu in
Chapter 3, Configuring the Module).
❑ 8-bit
❑ No parity
❑ 1 stop bit