Filter
Top Products
Configuring the Module 3 - 37
Saving Network Assignments
After you make configuration changes to the module, issue the SAVE
MODULE_PORT command as shown to save the interface network
configurations.
SAVE MODULE_PORT
Note: Failure to save the interface network configurations may
result in loss of configuration data.
Showing Module and Interface Configurations
To display module and interface configuration information, use the
following management commands:
❑ SHOW MODULE
❑ SHOW PORT
These commands are described below.
Show Module Command
The SHOW MODULE command enables you to display both brief
(no_verbose) and verbose information about a particular module. Brief is
the default.
The syntax of the SHOW MODULE command is:
SHOW MODULE {slot} {verbose}
{no_verbose}