Filter
Top Products
Installing the Module 2 - 7
Connecting a Terminal
You can connect a terminal or workstation running a terminal emulation
program to the RMON MultiProbe Module RS-232 port to:
❑ Configure IP address information for the RMON MultiProbe Module
interfaces
❑ Display the RMON MultiProbe Module configuration
To connect a terminal to the RMON MultiProbe Module:
1. Verify that the terminal is configured as follows:
❑ 8-bit data
❑ No parity
❑ 1 stop bit
❑ 9600 baud rate
Note: The RMON MultiProbe Module does not support XON and
XOFF.
2. Using an RS-232 null-modem cable, attach a terminal (or a
workstation running ASCII terminal emulation software) to the
RMON MultiProbe Module RS-232 port.