Filter
Top Products
Installing the Module 2 - 3
Quick Installation
Table 2-1 outlines the steps necessary to complete the installation of the
RMON MultiProbe Module. If you are familiar with installing 3Com
modules, use this table as a checklist. Otherwise, consult the remainder of
this chapter.
Table 2-1. Quick Installation Steps
Step Procedure Chapter/Section
1 Unpack the module. Chapter 2, Unpacking
Procedures section
2 Install the module into an open slot in
the hub.
Chapter 2, Installing
the Module section
3 Connect a terminal or management
workstation to the RS-232 console port
on the module faceplate.
Chapter 2,
Connecting a Terminal
section
4 Assign an IP address and subnet mask
for each RMON interface using a
BOOTP server or the configuration
menus.
Chapter 3, Assigning
the Interface IP
Address and Subnet
Mask section
5 Assign a default gateway for the
module using the configuration menus
or BOOTP.
Chapter 3, Assigning
the Module Default
Gateway section
6 Configure the RMON interfaces to a
network using either the DIP switch or
the SET PORT command.
Chapter 3, Assigning
Interfaces to Networks
section.
7 Configure optional module
parameters using the configuration
menus.
Chap ter 3, Configurin g
the Module