Filter
Top Products
Configuring the Module 3 - 33
Using the DIP Switch to Assign Networks
If you have an unmanaged hub, use the DIP switch on the module to assign
networks to the RMON MultiProbe Module interfaces. However, the DIP
switch settings are ignored if the following two conditions are met:
❑ A network management module is installed in the hub.
❑ The master management module has DIP_CONFIGURATION disabled.
The RMON MultiProbe Module contains an 8-position DIP switch (SW1).
This DIP switch allows you to configure and enable the three RMON
MultiProbe Module interfaces to the corresponding Ethernet networks.
Figure 3-8 shows the DIP switch location on the module
.
Figure 3-8. DIP Switch Location
1
SW1
CH1EN
CH2EN
NOT USED
NOT USED
NOT USED
NOT USED
NOT USED
Backplane DIN
Connector
CH3EN
12345678
On
Off
Dip Switches
0