Filter
Top Products
17
3M™ Digital WallDisplay
© 3M 2005. All Rights Reserved.
Installation and System Setup
Hanging the 3M Digital WallDisplay
Unpacking the 3M Digital WallDisplay
1. Place the shipping container face up on the floor
and open the end previous opened.
2. Slide the shipping tray out of the shipping
container.
3. Remove the accessory box(es) from the top
support.
4. Remove the top support.
5. Remove the plastic bag from the 3M Digital
WallDisplay by lifting the top of the unit and
pushing the bag towards the bottom of the unit.
Then set down the top.
6. Lift up the bottom and remove the bag completely.
7. Remove and set aside the tape holding the
projection arm in place.
8. Remove the projection arm shipping foam, by
opening the projection arm from the left.
9. Replace the tape to hold the projection arm in place
while hanging on the wall.