Filter
Top Products
21
3M™ Digital WallDisplay
© 3M 2005. All Rights Reserved.
Operation
Shutdown
1. Press the On/Off Button on the bottom center panel of the 3M Digital WallDisplay unit.
2. The lamp will turn off and the projector arm will return to its housing. The On/Off Button will flash red
as the arm closes.
Note: There is a 30-second reset period before the On/Off Button will function again. During this
period, the On/Off Button will flash red.
The fan will continue to run for approximately five minutes to cool the unit.
Note: If the 3M Digital WallDisplay will not be moved or disconnected, leave the Master Power Switch on
for your convenience.
Do not turn off the Master Power Switch or unplug the power cord before pressing the
On/Off
Button. After the On/Off Button is pressed, the fan continues for approximately five minutes to cool
the 3M Digital WallDisplay.