Filter
Top Products
Port Configuration
3-109
3
Web – Click Port, Rate Limit, Input/Output Port/Trunk Configuration. Enable the
Rate Limit Status for the required interfaces, set the Rate Limit Level, and click
Apply.
Figure 3-64 Output Rate Limit Port Configuration
CLI - This example sets the rate limit level for input and output traffic passing
through port 3.
Showing Port Statistics
You can display standard statistics on network traffic from the Interfaces Group and
Ethernet-like MIBs, as well as a detailed breakdown of traffic based on the RMON
MIB. Interfaces and Ethernet-like statistics display errors on the traffic passing
through each port. This information can be used to identify potential problems with
the switch (such as a faulty port or unusually heavy loading). RMON statistics
provide access to a broad range of statistics, including a total count of different
frame types and sizes passing through each port. All values displayed have been
accumulated since the last system reboot, and are shown as counts per second.
Statistics are refreshed every 60 seconds by default.
Note:
RMON groups 2, 3 and 9 can only be accessed using SNMP management
software such as HP OpenView.
Console(config)#interface ethernet 1/3 4-131
Console(config-if)#rate-limit input level 25 4-144
Console(config-if)#rate-limit output level 25 4-144
Console(config-if)#