Filter
Top Products
Command Line Interface
4-86
4
dot1x system-auth-control
This command enables 802.1X port authentication globally on the switch. Use the
no form to restore the default.
Syntax
[no] system-auth-control
Default Setting
Disabled
Command Mode
Global Configuration
Example
dot1x default
This command sets all configurable dot1x global and port settings to their default
values.
Command Mode
Global Configuration
Example
dot1x operation-mode Allows single or multiple hosts on an dot1x port IC 4-88
dot1x re-authenticate Forces re-authentication on specific ports PE 4-88
dot1x re-authentication Enables re-authentication for all ports IC 4-89
dot1x timeout quiet-period Sets the time that a switch port waits after the Max
Request Count has been exceeded before attempting to
acquire a new client
IC 4-89
dot1x timeout re-authperiod Sets the time period after which a connected client must
be re-authenticated
IC 4-90
dot1x timeout tx-period Sets the time period during an authentication session that
the switch waits before re-transmitting an EAP packet
IC 4-90
show dot1x Shows all dot1x related information PE 4-90
Console(config)#dot1x system-auth-control
Console(config)#
Console(config)#dot1x default
Console(config)#
Table 4-32 802.1X Port Authentication (Continued)
Command Function Mode Page