Filter
Top Products
Command Line Interface
4-108
4
Command Usage
• A port can only be bound to one ACL.
• If a port is already bound to an ACL and you bind it to a different ACL, the
switch will replace the old binding with the new one.
• You must configure a mask for an ACL rule before you can bind it to a port.
Example
Related Commands
show ip access-list (4-107)
show ip access-group
This command shows the ports assigned to IP ACLs.
Command Mode
Privileged Exec
Example
Related Commands
ip access-group (4-107)
map access-list ip
This command sets the output queue for packets matching an ACL rule. The
specified CoS value is only used to map the matching packet to an output queue; it
is not written to the packet itself. Use the no form to remove the CoS mapping.
Syntax
[no] map access-list ip acl_name cos cos-value
• acl_name – Name of the ACL. (Maximum length: 16 characters)
• cos-value – CoS value. (Range: 0-7)
Default Setting
None
Command Mode
Interface Configuration (Ethernet)
Console(config)#int eth 1/25
Console(config-if)#ip access-group david in
Console(config-if)#
Console#show ip access-group
Interface ethernet 1/25
IP access-list david in
Console#