Filter
Top Products
Setting Up and Testing the Desktop Unit
Campus-RS Desktop Unit User Manual 2-5
SET THE HDSL OPERATING MODE AND
T
RANSMISSION RATE
This section provides basic instruction for setting the HDSL Operating Mode
and transmission rate. The actual steps depend on the interface card in the
Desktop Unit. Refer to the interface card user manual for a description of
configuration and implementation options.
To set the HDSL Operating Mode:
1 With the interface card installed, connect the Desktop Unit to a power
source.
2 Turn on the power to the Desktop Unit, using the power button on the
back panel.
The unit performs a power-on test. After completing the test, the LCD
displays:
MARGIN (LOC/RMT)
1:XX/XX 2:XX/XX
This indicates successful completion of the power-on test. If the unit fails
the test, the LCD displays an error code. If this happens, contact ADC
Technologies, following the instructions in “Product Support” on page
C-1.
3 Press Escape four times to go to the top level menu.
4 Press Next until HDSL LINK CONFIG & STATUS displays, then press
Enter. OPERATING MODE displays.
5 Continue with one of the following sections, depending on whether you
are using Standard Mode or Extended Mode.
Next
Enter
Escape
CAMPUS RS
HDSL
Test
Port
LCD Menu buttons