Filter
Top Products
Deploying the Desktop Unit
Campus-RS Desktop Unit User Manual 3-3
Single-Loop Line
A single-loop line requires a single pair of wire. Use the same wiring for both
the local and remote sites. A single-loop line is compatible with the following
HDSL operating modes (see “Set the HDSL Operating Mode and
Transmission Rate” on page 2-5 to set the operating mode):
• 768 kbps Standard Mode
• all Extended Modes, supported by the interface card, that are available
with the Loop Mode set to 1 Loop
To set up a single-loop line:
1 Separate the two halves of the RJ-45 modular jack.
2 Connect the Ring wire to pin 2 of the jack.
3 Connect the Tip wire to pin 1 of the jack.
4 Proceed to “Connect the Desktop Unit to the HDSL Line” on page 3-4.