Filter
Top Products
IPv6 Commands show ipv6 rip routes
Release 5.1.6.R02 User Guide Supplement June 2005 page 2-81
-> show ipv6 rip routes detail 9900::/100
Destination = 9900::,
Mask length = 100,
Gateway(1) = fe80::2d0:95ff:fe12:e050,
Protocol = Local,
Out Interface = nssa23,
Metric = 1,
Status = Installed,
State = Active,
Age = 10544s,
Tag = 0,
Gateway(2) = fe80::2d0:95ff:fe12:da40,
Protocol = Rip,
Out Interface = bkbone20,
Metric = 2,
Status = Not Installed,
State = Active,
Age = 15s,
Tag = 0,
Release History
Release 5.1.6; command was introduced.
Related Commands
output definitions
Destination IPv6 address/address length of the destination.
Gateway IPv6 gateway used to reach the destination.
State Route status (Active/Inactive).
Metric Routing metric for this route
Protocol Protocol used to learn the route.
Mask Length Prefix Length.
Out Interface The interface used to reach the destination.
Status Route status (Active/Inactive)
Age The number of seconds since the route was last updated.
Tag The route tag value for the route.
ipv6 rip interface Creates/deletes a RIPng interface.
ipv6 rip interface metric Configures the RIPng metric or cost for a specified interface.
show ipv6 rip interface Displays all or specified RIPng interface status.