Filter
Top Products
debug ipv6 packet IPv6 Commands
page 2-22 Release 5.1.6.R02 User Guide Supplement June 2005
direction Allows filtering of packets based on the direction of flow:
all - debug both incoming and outgoing packets
in - debug incoming IPv6 packets
out - debug outgoing packets
from-cmm - debug packets received from the CMM.
from-ipv4 - debug packets received from an IPv4 interface.
to-cmm - debug packets sent to the CMM.
to-ipv4 - debug packets sent to an IPv4 interface.
output Specifies the destination for the debug information.
console - write debug information to the console screen or file
file filename - write debug information to the specified file.
Defaults
Platforms Supported
OmniSwitch 6624, 6648, 7700, 7800, 8800
Usage Guidelines
• Use the no form of the command to turn off IPv6 debugging.
• Options are additive across multiple command lines until reset with the “default” option.
Example
-> debug ipv6 packet defaults
Release History
Release 5.1.6; command was introduced.
parameter default
v6header concise
extheader payload
etherheader yes
raw bytes 0
board all
ether-filter no ether-filter
ipv6-filter no ipv6-filter
direction all
output console