Filter
Top Products
debug ipv6 trace-category IPv6 Commands
page 2-24 Release 5.1.6.R02 User Guide Supplement June 2005
debug ipv6 trace-category
Enables/disables specific IPv6 EDR trace categories. If a category is enabled (e.g., vlan, tunnel), switch
log messages generated for that category are written to the switch log.
debug ipv6 trace-category [all | default | general | cmm-control | ni-data | ni-control | vlan | tunnel |
neighbor | route | mip | ipc | cd | pm | sm | monitor | rtadv]
no debug ipv6 trace-category [all | default | general | cmmcontrol | nidata | nicontrol | vlan | tunnel |
neigh | route | mip | ipc | cd | pm | sm | monitor | rtadv]
Syntax Definitions
all Enable/disable all trace categories.
default Enable the default trace categories (general and monitor).
general Enable/disable the general trace category
cmm-control Enable/disable trace messages pertaining to the CMM control socket.
ni-data Enable/disable trace messages pertaining to the exchange of IPv6 pack-
ets with the NIs.
ni-control Enable/disable trace messages pertaining to the control messages
exchanged with the NIs.
vlan Enable/disable trace messages pertaining to VLAN interfaces.
tunnel Enable/disable trace messages pertaining to tunnel interfaces.
neighbor Enable/disable trace messages pertaining to the neighbor cache.
route Enable/disable trace messages pertaining to the forwarding table.
mip Enable/disable trace messages pertaining to MIP processing.
ipc Enable/disable trace messages pertaining to IPC communications.
cs Enable/disable trace messages pertaining to chassis supervision.
pm Enable/disable trace messages pertaining to port manager.
sm Enable/disable trace messages pertaining to session manager.
monitor Enable/disable debug and monitoring trace messages.
rtadv Enable/disable router advertisement trace messages.
Defaults
N/A
Platforms Supported
OmniSwitch 6624, 6648, 7700, 7800, 8800