Filter
Top Products
IPv6 Commands ipv6 rip debug-type
Release 5.1.6.R02 User Guide Supplement June 2005 page 2-71
ipv6 rip debug-type
Configures the type of RIPng messages to debug.
ipv6 rip debug-type [error] [warning] [recv] [send] [rdb] [age] [mip] [info] [setup] [time] [tm] [all]
Syntax Definitions
error Includes error conditions, failures, processing errors, etc.
warning Includes general warnings, non-fatal conditions.
recv Enables debugging in the receive flow path of the code.
send Enables debugging in the send flow path of the code.
rdb Debugs RIP database handling.
age Debugs code handling database entry aging/timeouts.
mip Debugs RIPng MIP messages.
info Provides general information.
setup Provides information during initialization.
time Debugs timeout handler.
tm Debugs RIPng Task Manager messages.
all Enables all debug options.
Defaults
N/A
Platforms Supported
OmniSwitch 6624, 6648, 7700, 7800, 8800
Usage Guidelines
• Use the no form of the command to disable a debug type.
• You can configure more than on debug type in the same command (see example below).
• Use the ipv6 rip debug-level command to set the debug level. This command sets the debug level for
all configured types. You cannot set different levels for each type.
Example
-> ipv6 rip debug-type error warning recv send
Release History
Release 5.1.6; command was introduced.