Filter
Top Products
IPv6 Commands ipv6 rip holddown-timer
Release 5.1.6.R02 User Guide Supplement June 2005 page 2-59
ipv6 rip holddown-timer
Configures the amount of time a route is placed in a holddown state. Whenever a route is seen from the
same gateway with a higher metric than the route in the RIB, the route goes into holddown. This excludes
route updates with an INFINITY metric.
ipv6 rip holddown-timer seconds
Syntax Definitions
seconds Time, in seconds, that a route will remain in a holddown state. Valid
range is 0 - 120.
Defaults
Platforms Supported
OmniSwitch 6624, 6648, 7700, 7800, 8800
Usage Guidelines
While in holddown, the route continues being announced as usual and used in the RIB. This interval is
used to control route flap dampening.
Example
-> ipv6 rip holddown-timer 60
Release History
Release 5.1.6; command was introduced.
Related Commands
MIB Objects
alaProtocolripng
alaRipngHolddownTimer
parameter default
seconds 0
ipv6 rip invalid-timer Configures the amount of time a route remains active in RIB before
being moved to the "Garbage" state.
ipv6 rip garbage-timer Configures the RIPng garbage timer value.