Filter
Top Products
www.aleratec.com
5
Precautions
Before you start:
Before you start using your 1:15 Blu-ray/DVD/CD Tower Publisher SLS, please
read the following to ensure proper operation.
Good care will help assure maximum
product life. Improper operating environment and misuse may void the warranty.
Choose a Good Location:
1. Allow adequate clearance for moving parts.
2. Do not place near heat sources such as radiators or air ducts, or in a place
subject to direct sunlight, mechanical vibration or shock.
3. If the duplicator was stored in a location where the temperature dropped below
32°F (0°C) within the past 24 hours, please leave the duplicator in a warm
room with temperatures at least 65°F (19°C) for 4 hours prior to powering it on
for the rst time. Failure to do so may cause irreparable harm and prevent the
duplicator from functioning.
Input Voltage Selection:
There is a voltage selection switch on the back of the unit, located directly above
where the power cord is connected to. This switch can be set for input power of
115 VAC (the default setting) or 230 VAC. Be sure it is set correctly for the input
voltage you will be using.
Operation:
Do not move the duplicator during operation. This may cause it to malfunction
during writing operation.
Avoid exposing the duplicator to sudden changes in temperature as condensation
may form on the lens inside the duplicator. Should the surrounding temperature
suddenly rise while the duplicator is on, wait at least one hour before turning
off the power. Operating the duplicator immediately after a sudden increase in
temperature may result in a malfunction during playback or writing operation.
Duplicator Limitations:
The duplicator will not copy any BD, DVD or CD disc that have Copy Protection
encoded inside. Typically, the movies you purchase or rent from the store will
contain copy protection. In addition to the copy protection limitation, the duplicator
cannot copy across formats. This means that you cannot copy a DVD master onto
a recordable CD. In addition, you cannot copy the same formats if the discs have
different maximum capacity limitations. This means that you cannot copy a single
layer DVD disc onto a double/dual layer DVD disc or vice versa. The recordable
blanks must be the same format and maximum capacity as the Master Disc you
intend to duplicate.