Aleratec 260203 Computer Accessories User Manual


 
www.aleratec.com
7
Overview
Unpacking the Unit
Your system was shipped in one box and contains the 1:15 Blu-ray/DVD/CD Tower
Publisher SLS and cables.
Carefully open the box and remove the top protective foam padding. Remove the
following:
1:15 Blu-ray/DVD/CD Tower Publisher SLS
2 Power Cords
1 USB 2.0 Cable
1 Quick Start Guide
1 Installation CD
Note: It is important to keep the original shipping container and packaging.
In the event you misplace your packaging and need to ship the 1:15 Blu-ray/
DVD/CD Tower Publisher SLS, you should first contact technical support
to purchase a new shipping container. Shipping the 1:15 Blu-ray/DVD/CD
Tower Publisher SLS without proper packaging will void your warranty.
Connect the Cables and Apply Power
Plug the 2 power cords into the power supply of the 1:15 Blu-ray/DVD/CD Tower
Publisher SLS, also located on the rear side (make sure the red switch is set at 115
VAC for US operation). Plug into a standard 115 VAC outlet.
Plug the USB 2.0 Cable into the USB connector located on the center rear of the
1:15 Blu-ray/DVD/CD Tower Publisher SLS. Connect the other end of the USB
cable into an available USB 2.0 port on your PC.
Note: Use only with a USB 2.0 port. This system cannot be used with USB
1.1, as this will greatly affect system performance. If Windows displays a
message that a fast USB device is detected on a slow USB port, then you
will need to upgrade your computer by adding a USB 2.0 port.