Filter
Top Products
Chapter 2: Installation
68
on an AT-CM70S Line Card
2. Connect the other end of the cable to an RS-232 port on a terminal or
a personal computer with a terminal emulation program.
3. Set the terminal or terminal emulation program to the following
defaults:
Baud rate: 115200 bps
Data bits: 8
Parity: None
Stop bits: 1
Flow control: None
Note
The settings are for a DEC VT100 or ANSI terminal, or an equivalent
terminal emulation program.
The software initializes and then the login prompt is displayed.
4. When prompted, enter a username and password.
To configure the chassis settings, enter “manager” as the
username. The default password for manager access is “friend”.
To just view the settings, enter “operator” as the username. The
default password for operator access is “operator”.
Usernames and passwords are case-sensitive.
The Main Menu is displayed, as shown in Figure 46.
Figure 46. AT-S70 Main Menu
Allied Telesis AT-CV5M01 Management Module Software
CV-5000 Chassis
Main Menu
Module Status and Configuration
Remote Module Status and Configuration
Administration
Image Download
System Configuration
Quit