Filter
Top Products
Chapter 3: Working with Line Cards and other Modules
82
Installing an AT-PWR14 AC Power Supply
The AT-CV5000 chassis is shipped with two slots in the rear designated
for the power supplies, but without any power supplies installed. You must
install at least one power supply in order to power on the chassis.
Caution
The AT-CV5000 Media Converter chassis can contain two power
supplies of the same type (AC or DC) or a combination of the two
types with the same power ratings. Make sure not to mix power
supplies with different power ratings in the same chassis.
For information on the power supply module, refer to the
documentation that is shipped with the module.
Note
You can install an additional AT-PWR14 AC power supply while the
existing power supply is powered ON.
Note
The AT-PWR14 AC power supply is shipped with four power cords,
one each for North America, the UK, Europe, and Australia. Locate
the correct power cord for your location before beginning this
procedure.
To install the AT-PWR14 AC power supply, perform the following
procedure:
1. Remove the AT-PWR14 AC power supply from its shipping package
and store the package in a safe place.
Note
You must use the original package if you need to return the unit to
Allied Telesis.
2. Select the power supply slot in the AT-CV5000 chassis where you
want to install the AT-PWR14 AC power supply.
3. Make sure that the power switch for that slot is in the OFF position.
4. Remove any slot cover that may be covering that slot.