Filter
Top Products
AT-CV5000 Media Converter Chassis Installation Guide
79
Installing an AT-CM70S Line Card
The AT-CM70S line card is a double-slot line card that takes up two line
card slots in the chassis. Therefore, the process for installing this card
differs slightly from the process for installing other Converteon™ line
cards.
To install an AT-CM70S line card, perform the following procedure:
1. Remove the AT-CM70S line card from its shipping package and store
the package in a safe place.
Note
You must use the original package if you need to return the unit to
Allied Telesis.
2. Remove the AT-CV5PNL1 blank slot covers from two adjacent line
card slots.
Keep the blank slot covers in a safe area in case you remove the line
card. The blank slot covers are used to keep dust from getting into the
chassis and maintains proper airflow, cooling, and ventilation
throughout the chassis.
3. Locate the top and bottom alignment guides inside the line card slots,
as shown in Figure 24 on page 53.
4. Set the line card’s DIP switches.
For more information on the DIP switch settings, refer to the
Converteon™ Media Converter Line Cards Reference Guide.
5. Align the back edge of the line card with the top and bottom alignment
guides located inside the slot.
Warning: Remove all metal jewelry, such as rings and watches,
before installing or removing a line card from a powered-on
chassis.
E26
Caution Be sure to observe all standard electrostatic discharge
(ESD) precautions, such as wearing an antistatic wrist strap, to
avoid damaging the device. A line card can be damaged by
static electricity.