Allied Telesis AT-2716POE Network Card User Manual


 
AT-2716POE Fast Ethernet Fiber & PoE Adapter Installation and User’s Guide
30
Installing the NDIS Driver Software
The system automatically detects new hardware and prompts you to
install the driver software for that device when a Windows XP system first
boots up. The same windows are displayed after an existing device driver
is removed.
There are two installation procedures:
“Using the Driver Installer” on page 30
“Updating the Adapter Software” on page 33
Note
The adapter must be physically installed in your system before
installing the driver software. See Chapter 2, “Installing the
Hardware” on page 17 for details.
Not
If the Windows XP system detects an adapter and installs a
default driver, update the driver as described in “Updating the
Adapter Software” on page 33.
Note
If there is an onboard Broadcom network interface, the native
Broadcom driver may load. It is recommended to install the latest
driver supplied by Allied Telesis.
Note
After XP driver installation AT-2716POE ATMux Configuration
software must be installed to complete the bridging function of the
adapter, refer to Chapter 5 for details.
Manual Driver
Install
When you boot up the operating system after installing the adapter card,
a series of Found New Hardware windows are displayed. You must have
Administrator privileges to install the driver software.
Note
Before beginning this procedure, verify that the Windows XP
system has been upgraded to the latest version with the latest
service pack applied.