Filter
Top Products
AT-2716POE Fast Ethernet Fiber & PoE Adapter Installation and User’s Guide
69
Modifying Advanced Properties
In most cases, the default property values available on the Advanced Tab
are appropriate although you can change any of the available options to
meet the requirements of your system. You must have Administrator
privileges to modify the driver software.
After you have installed the driver software, you can use the following
procedures to verify or change the adapter properties:
Updating the 802.3az EEE property on page 70.
Updating the ARP Offload property on page 70.
Updating the EEE Control Policies property on page 70.
Updating the Ethernet@WireSpeed property on page 70.
Updating the Flow Control property on page 70.
Updating the Interrupt Moderation property on page 71.
Updating the IPv4 Checksum Offload property on page 71.
Updating the Jumbo MTU property on page 71.
Updating the Large Send Offload (IPv4) property on page 71.
Updating the Large Send Offload v2 (IPv4) property on page 72.
Updating the Large Send Offload v2 (IPv6) property on page 72.
Updating the Network Address property on page 72.
Updating the NS Offload property on page 72.
Updating the Priority & VLAN property on page 72.
Updating the Receive Side Scaling property on page 73.
Updating the RSS Queues property on page 73.
Updating the Speed & Duplex property on page 73.
Updating the TCP/UDP Checksum Offload Ipv4 property on page 73.
Updating the TCP/UDP Checksum Offload Ipv6 property on page 74.
Updating the Virtual Machine Queues property on page 74.
Updating the VLAN ID property on page 74.
Updating the VMQ Lookahead Split property on page 74.
Updating the VMQ VLAN Filtering property on page 74.
Updating the Wake Up Capabilities property on page 75.
Updating the WOL Speed property on page 75.
Note
After you upgrade the driver software, the Advanced Properties may
change.
Note
The procedures in the sections listed above may differ slightly if the
“Classic Start Menu” is set on your computer.