Filter
Top Products
Advanced Control Suite User’s Guide
35
speed and duplex mode. A speed of 1 Gbit/s is enabled by
selecting Auto, when that speed is supported.
Wake Up Capabilities. The Wake Up Capabilities property enables
the network adapter to wake up from a low-power mode when it
receives a network wake-up frame. Two types of wake-up frames are
possible: Magic Packetô and Wake Up Frame.
Note
This parameter is available only for copper devices and is not
displayed for the AT-2916SX and AT-2931SX adapters.
– Both (default). Selects both Magic Packet and Wake Up
Frame as wake-up frames.
– Magic Packet. Selects Magic Packet as the wake-up
frame.
– None. Selects no wake-up frame.
– Wake Up Frame. Selects Wake Up Frame as the wake-up
frame and allows the network adapter to wake the system
when an event such as a ping or an Address Resolution
Protocol (ARP) request is received.
WOL Speed. The WOL Speed property sets the speed at which the
network adapter connects to the network while the network adapter is
in Wake on LAN mode. By default, the WOL Speed property is set to
Auto.
Note
This parameter is available only for copper devices and is not
displayed for the AT-2916SX and AT-2931SX adapters.
– 10 Mb. Sets the speed to 10 Mbit/s. This is the network
speed when the system is in a standby mode awaiting a
wake-up frame.
– 100 Mb. Sets the speed to 100 Mbit/s.
– Auto (default). Sets the speed for optimum network
connection.
Network Test
Tab
In the Network Test tab, you can verify IP network connectivity. This test
verifies if the driver is installed correctly and tests connectivity to a
gateway or other specified IP address on the same subnet. The Network