Filter
Top Products
Advanced Control Suite User’s Guide
57
Note
When you create Generic Trunking and Link Aggregation teams,
you cannot designate a Standby Member. Standby members work
only with Smart Load Balance and Failover and SLB (Auto-Fallback
Disable) types of teams.
Note
For an SLB (Auto-Fallback Disable) team, when you want to restore
traffic to the load balance members from the standby member, click
the Fallback button on the Team Properties Tab.
Note
Not all network devices made by other vendors are supported or
fully certified for teaming.
9. Configure the Team IP address if necessary by choosing Start >
Settings > the team name > Properties.
If other network devices in your computer use TCP/IP bindings, the
TCP/IP Properties windows is displayed.
10. Configure the IP address and any other necessary TCP/IP
configuration for the team and click OK when finished.
Modifying a
Team
After you have created a team, you can modify the team in the following
ways:
Change the type of team
Change the members assigned to the team
Add a VLAN
Remove a team or a VLAN
To modify a team, perform the following procedure.
1. Select the team name.
2. From the Tools menu, click Configure a Team.
The Welcome page of the Broadcom Teaming Wizard is shown in
Figure 11 on page 44.
3. Click Next.
The Team Name page asks for a name for the team, as shown in
Figure 12 on page 44.
4. Type the name of the team you want to modify and click Next.