Filter
Top Products
3ware Disk Manager (3DM 2)
50 3ware 9000 Series Serial ATA RAID Controller User Guide
Figure 18. However, if the unit was a Single Disk, only information about one
disk would be shown.
Details on this page may include all or some of the following information
described below.
To see details about a particular drive, click the Port #. You’ll see a list of all
drives, with the drive you selected highlighted.
Status. The operational status of the unit or subunit: OK, Rebuilding,
Initializing, Verifying, Degraded, or Inoperable (missing drives). When a unit
is Rebuilding, Initializing, or Verifying, the percentage (%) complete is also
shown.
Capacity. The total capacity of the unit (capacities of subunits are not shown).
Type. The type of unit or subunit it is. RAID 0, RAID 1, RAID 5, RAID 10,
RAID 50, Single Disk, Spare, JBOD, or Disk
Stripe. The stripe size of the unit, if applicable.
Subunits. If the unit has subunits, details of the subunits are shown.
Port #. If the Type is Disk, Single Disk, JBOD, or Spare, the port to which the
drive is connected is shown. For multiple drive units, the port numbers are
shown in the subunits section. The port number is a link to the Drive
Information page.