Filter
Top Products
InfraStruXure Power Generation System 81
Appendix: Custom Installations
If Source 2 is a Second Utility
Differences in your system from information presented in this manual
The ATS was designed for operation with an APC InfraStruXure generator, and this manual assumes
that Source 2 is an APC InfraStruXure generator. If using a secondary utility instead of a generator,
almost all references to the “generator” should be considered references to your second utility as
well. However, the following sections will not apply to your system and should be disregarded:
• “Generator start sequence” on page 7
• “Generator cool-down” on page 7
• “Fuel monitoring/runtime calculation” on page 9
• “Communication converter,” (item 4) on page 13
• “Resetting automatic operation on the generator” on page 20
• “Generator” on page 37
• “Fuel Alarm Limits” on page 44
Note
If your installation includes a secondary utility source, the APC Field Service Engineer
performing your start-up will configure your ATS to operate with two utility sources.