Filter
Top Products
InfraStruXure Power Generation System 57
How to Access the ATS Network
Management Interface
Web interface
You can use Microsoft
®
Internet Explorer 5.0 (and higher) or Netscape
®
4.0.8 (and higher, except
Netscape 6.x) as your browser to access the ATS through its Web interface. Other commonly
available browsers may also work, though they have not been fully tested by APC.
When utilizing the Web browser to configure ATS options or to view the event log, use either of the
following:
• The HTTP protocol (enabled by default), which provides authentication by user name and
password (but with no encryption).
• The more secure HTTPS protocol, which provides extra security through Secure Socket Layer
(SSL) to encrypt user names, passwords, and data being transmitted. It also provides
authentication of Network Management Cards by means of digital certificates.
To access the Web interface and configure the security of your device on the network:
1. Identify the ATS by its IP address or DNS name (if configured).
2. Enter the user name and password (the defaults are apc and apc for an Administrator, and
device and apc for a Device Manager).
3. Select and configure the type of security you want (this option is available only for
Administrators).
Note
Use the procedures in this section to access the ATS from the public LAN. If you want
to access the ATS through the APC LAN, refer to the InfraStruXure Manager’s
Installation and Quick-Start Manual.
See also
Refer to “Security” in the InfraStruXure Power Generation System’s on-line
Network Management User’s Guide for information about choosing and setting up
your network security. Use the Web/SSL option of the Network menu to enable
or disable the HTTP or HTTPS protocols.