Filter
Top Products
Fastmark 600 Series User's Guide 14
UNPACKING AND INSPECTION
This section is provided to assist you in removing the printer from the shipping container and
setting it up in the application environment. Inspect the shipping carton and contact the carrier
directly to report any suspected damage.
1. With the shipping container in the upright position, remove the top foam packing piece.
2. Carefully, lift the printer straight up out of the box.
3. Remove the printer from the plastic bag and place the printer on a flat stable surface.
4. Remove the accessory kit and supplies.
5. Inspect the shipping container and the printer for any damage that may have occurred
during shipping.
Note:Save the box and all packing materials for future use, in the event the
printer needs to be shipped. Units returned for service in non-
approved packaging may void the warranty or increase repair costs
due to shipping damage.
Verify that the printer box contains the following materials when unpacking:
a. Printer
b. 3 inch Media spindle adapter
c. AC Power Cord
d. RS-232 Serial Cable (not shown in below figure)
e. CD that contains User's manual and Windows drivers
f. A sample media roll
g. A sample ribbon roll and a take-up ribbon core
h. Two Ribbon Core adapters for ribbon cores that are smaller than 4.325 inches in width.
Figure 4 – Shipped with Printer
Printer
Sample Ribbon
Sample Media
Power Cord
CD
Ribbon Core Adapter
3” Media Adapter